Skoda Karoq 2018 Workshop Manual page 411

13 - Exhaust gas turbocharger
❑ Removing and installing
14 - Gasket
❑ put it onto the catalyst
❑ Replace after disassembly
15 - Mounting bracket
❑ for exhaust gas cleaning module
❑ with balancing element
❑ Prepare balancing element for installation
16 - Screw
❑ Tightening torque and tightening order
17 - Screw
❑ Tightening torque and tightening order
18 - Screw
❑ 9 Nm
19 - Measurement pipe
❑ to differential pressure transmitter - G505-
❑ Union nut tightening torque 45 Nm
20 - Screw
❑ Tightening torque and tightening order
21 - Screw
❑ Tightening torque and tightening order
22 - Mounting bracket
❑ for exhaust gas cleaning module
❑ with balancing elements
❑ Prepare balancing element for installation
23 - Screw
❑ Tightening torque and tightening order
24 - Exhaust gas cleaning module
❑ Particle filter with catalyser
❑ Removing and installing
25 - Screw
❑ Tightening torque and tightening order
Bracket -2- for exhaust gas cleaning module - tightening torques
and tightening order
– Tighten screws in steps in the specified sequence:
Stage Bolts
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
1. -3-
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
2. -1-
3. -3-
1.6/85; 2.0/110; 130; 140 kW TDI CR engine - Edition 06.2017
⇒ "1.2 Removing and installing exhaust gas turbocharger", page 268
⇒ page 263
⇒ page 412
⇒ page 412
⇒ page 403
⇒ page 403
⇒ "2.3 Removing and installing exhaust gas cleaning module", page 407
⇒ page 412
Specified torque
by hand as far as the stop
20 Nm
20 Nm
Karoq 2018 ➤ , Kodiaq 2017 ➤
⇒ page 411
⇒ page 411
2. Cleansing exhaust emissions
403