Answering Calls; Hanging Up; Cordless Handset Leds - Mitel 50005070 User Manual

Cordless Devices

Answering Calls

To answer a call:

Hanging Up

To hang up:

Cordless Handset LEDs

The handset has two LEDs:
•
•
The handset is blinking, when the LED is on and off for an equal amount of time. The handset is
winking, when the LED is on for a short period of time and off for a longer period of time.
Blue
Green
NOTE
Page 52
Do one of the following:
•
Lift the cordless handset.
•
If the handset is already out of the cradle, press the hookswitch button on the
handset.
Do one of the following:
•
Replace the cordless handset in the cradle.
•
Press the hookswitch button on the handset.
Blue – indicates the operational status of the handset.
Green – indicates the status of the electrical charge of the battery.
Led Color LED State
Solid
Blinking
Winking
Off
Solid
Blinking
Off
It is normal for the handset LED to cycle between blinking and solid as battery
charge is maintained.
Indicates
Handset is muted.
Handset is in pairing mode.
Active audio path between handset and
module.
No audio path between handset and module.
Battery is dead.
Battery is fully charged.
Battery is charging.
When handset is cradled and the LED does
not flash or illuminate, this indicates an
absence of battery power. During the first
30 – 60 minutes that the light is off, the
battery may be trickle charging. If that is the
case, the LED resumes normal behavior
within that 60–minute period. If the LED
remains off for more than 60 minutes, then
either the battery is no longer chargeable or
there is a problem in the charging circuit.
Mitel ® Model 5330/5340 User Guide – Issue 2, October 2008