Table of Contents
Advertisement
8. Canceling a print job and deleting print
data
•To cancel a print job in progress and delete the print data:
Press the [BACK/CLEAR] key during printing. Printing will stop and a
message asking for confirmation to delete the job will appear.
To delete the data, press the [OK] key.
To cancel deletion, press the [BACK/CLEAR] key. Printing will resume.
•To delete print data of a reserved job (that waits for printing):
Print data transmitted from computers will be stored in this printer (up to
99 jobs) and will be output sequentially. To delete print data of a
reserved job before starting printing, press the [
the desired data in the message display.
If you press the [BACK/CLEAR] key at this time, a confirmation
message for deletion will appear. To delete the data, press the [OK] key.
To cancel deletion, press the [BACK/CLEAR] key. Printing will resume.
9. Setting the paper size and type
When the paper size or type is changed in a paper tray, set them
referring to the following procedure.
1) Press the [MENU] key repeatedly until "CUSTOM SETTINGS"
appears in the message display.
2) Press the [OK] key.
When the [OK] key is pressed, "TRAY SETTING" will appear in the
message display.
3) Press the [OK] key.
When the [OK] key is pressed, the message shown to the left will
appear in the message display.
TRAY SETTING
4) Select the desired paper tray.
Press the [
] or [
] key repeatedly until the desired paper tray is
indicated in the display.
5) Press the [OK] key.
The paper size and paper type of the tray selected in step 4) will
appear.
•If TRAY 1 is selected in step 4), the message shown to the below will
appear in the display.
LETTER
PLAIN
] or [
] key to display
TRAY1
AR-P350 MACHINE OPERATION-4
6) Press the [
] key.
•If TRAY 1 is selected in step 4), the message shown to the left will
appear in the display.
CHANGE TRAY1
SETTING OK?
7) Press the [OK] key.
To cancel the setting change, press the [BACK/C] key to return to
step 4).
NOTE: Special paper such as thick paper, transparency film, labels, and
postcards can be set for tray 2 and the bypass tray. Envelopes
can be set only for tray 2.
8) Select the paper type that has been set in the tray.
Press the [
] or [
] key repeatedly until the paper type that has
been set appears.
PLAIN
OK?
9) Press the [OK] key.
10) Ensure that the desired paper size is selected.
•Press the [
] or [
] key repeatedly until the desired paper size
appears.
LETTER
OK?
•Depending on the selected tray, a selection for"AUTO-AB" and "AUTO-
INCH" may appear
"AUTO-AB": Select when you have set AB system paper.
"AUTO-INCH": Select when you have set inch system paper.
When the paper system is changed from the inch system to the AB
system or vise versa, the paper type must be designated. Select the
paper type.
•If you have set paper of non-standard size, select "NON STANDARD".
This size can be selected when tray 2 or the bypass tray has been
selected in step 4).
11) Press the [OK] key to terminate the setting.
Advertisement
Table of Contents
