Table of Contents
Advertisement
[7] DISASSEMBLY AND ASSEMBLY, MAINTENANCE
1.Maintenance System Table
A. Engine section
Check (Clean, replace, or adjust as necessary.)
Unit name
Drum peripheral
Drum
Cleaner blade
Toner reception seal
Side molt
Transfer roller
Discharge plate
TR bearing (F/R)
Transfer roller collar
TR gear
Screen grid
Drum separation pawl UN
Charger case (M/C)
Charging plate
(saw teeth)
Developing section
Developer
DV blade
DSD collar
DV side seal F
DV side seal R
Toner cartridge
Fusing section
Upper heat roller
Lower heat roller
Upper separation pawl
Lower separation pawl
Thermistor
Upper heat roller gear
Paper guides
Gears
Filters
Ozone filter
Paper feed section
Paper feed roller
Torque limiter
Transport section
PS follower roller
Paper exit reverse section
Transport rollers
Transport paper guides
Paper dust remover
Drive section
Gears(Specified position)
Belts
Image quality
Other
Sensors
Note 1:Replacement reference: Use the counter value of each paper feed port as the replacement reference.
Clean
When
Part name
calling
(
)
(
)
Paper feed roller/Torque limiter section: 80K or 2 years
AR-P350 DISASSEMBLY AND ASSEMBLY, MAINTENANCE-1
Replace
Adjust
50K 100K 150K 200K 250K 300K 350K 400K
Maintenance cycle : 50K
Lubricate
Move position
Remark
Installed when shipping
Supplied when installing
Attached when installing./
EX Japan: 814g,
user replacement for every 30K.
Clean and remove paper dust.
Note 1
Note 1
Advertisement
Table of Contents
