Table of Contents
Advertisement
5. Option expansion memory installation
A. Hard disk (ARHD3), PS3 Expansion kit (ARPK1),
print server card (AR-NC5J), expansion memory
(commercially available one)
Note: Before performing this installation work, check that the data lamp
on the operation panel is neither lighting nor blinking.
1) Turn off the power of the machine and disconnect the power plug
from the power outlet.
2) Remove all the cables (such as printer cables) from the control PWB.
In the case of the printer control PWB
3) Remove the control PWB.
4) Install each option.
In the case of the MFP control PWB
1)
2)
1)
AR-P350 UNPACKING AND INSTALLATION-5
<Printer model>
Expansion memory
PS3 Expansion kit
Print server card
Note: To prevent breakage by static electricity, take the following
measures.
a. Use an earth band for installing procedures.
b. Keep the memory in the protection bag, and remove it from the bag
only just before installation.
5) Install the control PWB to the machine.
6) Attach the cables which were removed before installation of the
memory.
7) Insert the power plug into the power outlet, and turn on the power.
B. Print test
1) Press the [MENU] key to display "USER SETTING."
2) Press the [OK] key to select the menu.
3) Use [
] and [
] keys to select List Print, and print the setup list or
demonstration page to check the print quality.
4) Press the [MENU] key again to return to the normal menu.
C. Other options
For installation of the other options, refer to the Service Manual of each
option.
HDD PWB
PWB fixing
screw
Cover
Advertisement
Table of Contents
