Canon CN8x15 Operation Manual page 153

Specifying the Input Route for Command Signals from the Camera
There are two input routes for command signals from the camera: via the mount and via the 12-pin cable. This setting
specifies the input route for command signals from the camera. The default setting is "Mount," and in this case command
signals received via the mount are given priority.
However, the command signals via the 12-pin cable are received automatically if no command signals are input via the
mount. When the "Cable" setting is selected, only command signals received via the 12-pin cable are used.
Initial Top Screen
[ ]
1
MENU
[ Basic ] [Adj]
[ I-Gain ] [Trk]OFF
[I-Tq]H
Fr1P
A
Info Screen
Info
S/N
OFF
3D
Encoder: OFF
Info
IND
CamSeri: ON
I/Fprior Cable
/ i
Info
IND
CamSeri: ON
I/Fprior
Mount
/ i
Options
Description Via mount
(D): Default value
MENU
1
Press
The display switches to the Info screen.
2
Press
[I/Fprior] is underlined.
3 Press
Press left or right to switch the function {Cable} or {Mount}.
(D)
Mount Cable
Via 12-pin cable
Info
× 2
once and twice.
five times.
or .
× 5
E151
4. Operation in Full Mode
Note: Set {Mount} when using the
auto focus function of the
camera. (For the camera models
that support the auto focus
function, contact your Canon
dealer.)
or