Canon CN8x15 Operation Manual page 110

4. Operation in Full Mode
(3) Responding to Errors
If copying between lenses fails, check the following.
Error Screen
Lens Connect
Error!!
Copy Error!!
Checking Item
Confirm that the dedicated cable
(20 pin–20 pin) is connected.
Confirm that the target lens is
on.
Confirm that the drive unit of the
target lens is the same model.
Confirm that the dedicated cable
(20 pin–20 pin) is connected.
Confirm that the source and
target lenses are on.
Problem
Settings cannot be copied
between lenses unless the
cable is connected.
Settings cannot be copied
unless both the source and
target lenses are on.
Settings cannot be copied
between lenses of different
generations of drive units.
The message at left is displayed
if the lenses are disconnected
during copying, if a power
outage occurs, or if a lens is
turned off. In this case, copying
is interrupted, which prevents
the settings from being copied
correctly.
E108
Responding
Securely connect the cable
between the source and target
lenses, and follow the steps to
copy again, from the start.
Turn on both the source and
target lenses, and follow the
steps to copy again, from the
start.
Contact Canon or your dealer
for details on models of drive
unit that can be used to copy
settings.
Confirm that the source and
target lenses are on, and that
the cable is securely connected.
Press the Display switch to
return to Screen A, and follow
the steps to copy again, from
the start.
Screen A
User 1
Copy
ToOtherLens
Access: Unlock