Lincoln Electric Vernon Tool MasterPipe Compact Profiler Operator's Manual page 38

Performing a Test Cut:
Setting the Pipe Diameter and Plate Origin:
Select the PLATE SETUP button.
In the Plate Setup panel under PIPE, enter the pipe O.D. of 3" sch 40 (3.5")
Jog the Y axis in the positive direction until you reach the end of the pipe opposite the chuck.
Press the SET PLATE ORIGIN button. This tells the machine where the end of the loaded material is located and where
to start the program.
3.500
Vernon Tool MasterPipe Compact Profiler
Page 29