Table of Contents
Advertisement
Performing a Test Cut:
Since these test pieces were created in WinMPM, the kerf is compensated. Select the 'Yes' button under the "Is Job Kerf
Compensated" option. Click the browse button and locate either the 4000 TC Saddle Cut FC80.gm or 4000TC Saddle Cut
FC125.gm file, located in the WinMPM folder at C:\WinMPM\Torchmate VMD Jobs\ . Each file has specific settings to either
the FlexCut 80 or FlexCut 125 plasma cutters, please verify you open the appropriate file for your model plasma cutter.
Verify that the "Is Job Kerf Compensated" selection is set to Yes.
With the job selected and the "Is Job Kerf Compensated" selection set to Yes, click the OK button to open the job.
Vernon Tool MasterPipe Compact Profiler
Page 27
Advertisement
Table of Contents
