Table of Contents
Advertisement
Remove the chuck box cover:
The
MasterPipe Compact Profiler
the rear of the machine drive assembly. The pneumatic connection for the air ventilation is also located under this
cover. Provided is the steps to follow to remove this cover to make these attachments.
This process requires a 3/16" hex head wrench
Instructions:
1.
Remove the 3/16" hex head bolts from the slotted tabs that hold the chuck box cover in place.
2.
Save the screws for reinstallation.
3.
To remove the chuck box cover, pull the cover up and out from the four slots in the chuck box cover.
Set cover aside until air and ground are attached.
4.
To reinstall the chuck box cover, align the four tabs into the slots and realign the 3/16" hex head bolts.
Tabs:
Slotted Tab:
3/16 hex head
bolt
Tabs:
User Guide
is equipped with a rotating ground located under a protective metal cover at
Page 4
Advertisement
Table of Contents
