Power/Air Requirements - Lincoln Electric Vernon Tool MasterPipe Compact Profiler Operator's Manual

Power/Air Requirements

Please refer to the FlexCut operators manual for complete installation and operation guidelines. Only a qualified
electrician should connect the input leads to the FlexCut Plasma unit. Connections should be made in accordance with all
local and national electrical codes. Failure to do so may result in bodily injury or death.
The profiling machine has a single 120v NEMA 5-15P plug that powers the table and computer/monitor.
The FlexCut 80 is rated for 208 VAC through 575 VAC input voltages, single or three phase and 50 or 60 Hz.
Before connecting the machine to power, be sure the input supply voltage, phase and frequency all match those listed on the
machine rating plate.
The FlexCut 80 automatically senses and adjusts to work with any input voltage, phase or frequency listed on the rating plate. No
reconnect switch settings are required. The power supply cord is supplied without an attachment plug to accommodate single
phase or three phase installations.
Warning:
The FlexCut on/off switch is not
intended as a service disconnect
for this equipment. Only a
qualified electrician should
connect the input leads to the
Torchmate 4400/4800/4510.
The Vernon Tool MasterPipe Compact Profiler machine requires clean, dry, oil-free compressed air or nitrogen. A high
pressure regulator MUST be used with a compressor or high pressure cylinder.
Supply pressure must be between 87-110 psi (6-7.6 bar) with flow rated rates of at least 300 SCFH or 140 SLPM.
AIR SUPPLY PRESSURE SHOULD NEVER EXCEED 110 PSI OR DAMAGE TO THE MACHINE MAY OCCUR!
A standard nominal 5 micron in-line filter is recommended, but for optimal performance, select a pre-filter with a 3 micron
absolute rating. Air must be supplied to the plasma with 3/8" inside diameter tubing and 1/4 NPT quick disconnect coupler.
Air lines should be run as to not create a trip hazard. We recommend using the TMS-214-0000-00 approved air filtration
assembly, available from www.torchmatestore.com
Vernon Tool MasterPipe Compact Profiler
Page 3