Step 3 Starting The Copy Job - Xerox Wide Format 6705 System User Manual

2.1.3
The following describes how to load the document and start copying.
If you hold down or pull the document while it is being scanned, the document may get jammed.

Important
When loading a hole-punched document, insert the edge with the holes last. If you insert the edge with the holes

first, the document may get jammed.
Steps
St
2
1.
Align the document against the document guide with the side
to be copied face down, and insert it all the way until it stops.
Note
The document is automatically conveyed and stops momentarily.
Then the machine automatically starts scanning the
document.
Important
Note
2.
Remove the document that is output.
2.1 Copying Procedure
80

Step 3 Starting the Copy Job

You can shift the document guide to the right to shift

the scanning position of the document.
Do not release your hands from the document

until it is conveyed. If the document is long, it
might fall off the machine.
When the scan start mode is set to [Manual

Start] under System Settings, press the <Start>
button on the control panel.
For information on how to set Manual Start,
refer to "Scan Start Mode" (p. 297).
When a problem occurs, an error message is

displayed on the touch screen. Resolve the
problem according to the message.
Document guide