Wps Setup; Using The Wps Button - ZyXEL Communications NU-AP699E9N3 User Manual

Table of Contents

NU-AP699E9N3 Wireless Router User Manual

Enable WDS Function: Enable the WDS function if you want to use this

function. Note that the WDS function cannot be enabled if the channel is set

to Auto.

Enable Wireless Clients Association: If not selected, the wireless basic

station does not transmit any signals to clients that are directly connected to

it.

Central Base Station: In this mode, the router serves as a basic station to

communicate with repeaters. The basic station forwards the data of

communication between repeaters to the destination repeaters. Repeaters

should be configured accordingly. Note that a wireless basic station can be

configured with up to four repeaters.

Repeater MAC Address 1/2/3/4: Enter the MAC address of the repeater.

After finishing settings, click Apply to save the settings.

For WDS application description, refer to section 6.4.3 "WDS Application".

8.5.5 WPS Setup

WPS refers to Wi-Fi Protected Setup.

You can use WPS to establish wireless connection in a quick and secure way if the

uplink AP or terminal (for example, the network adapter) has the WPS function. It is

suggested to first configure wireless encryption for the uplink AP. If you change the

wireless encryption mode after having establishing wireless connection using WPS,

you must use WPS to establish wireless connection again. Note that if the wireless

client does not support WPS you must manually configure the wireless client (such

as SSID, security mode, and password) to make it have the same SSID and

wireless security settings as the router.

The following describes how to configure WPS for the router mode.

In the Router mode with WDS disabled, press the WPS button on the side panel of

NU-AP699E9N3 and the WPS button on the client device. NU-AP699E9N3 can

perform WPS encrypted connection to the downlink client device.

Table of Contents