ZyXEL Communications EX3510-B1 User Manual page 32

Table 5 Configuration Menus Summary (continued)
LINK
Multicast Status
WLAN Station
Status
Steering Status
Maintenance
System
User Account
Remote
Management
SNMP
Time
E-mail
Notification
Log Settings
Firmware
Upgrade
Backup/Restore
Reboot
Diagnostic
2.2.1.2 Icons
The navigation panel provides some icons on the right hand side.
Chapter 2 Web Configurator
TAB FUNCTION
IGMP Status Use this screen to view the status of all IGMP settings on the Zyxel Device.
MLD Status Use this screen to view the status of all MLD settings on the Zyxel Device.
WLAN Station Use this screen to view the wireless stations that are currently associated
Status with the Zyxel Device.
Steering Status Use this screen to view the AP and band steering records.
System
Use this screen to set Device name and Domain name.
User Account Use this screen to change user password on the Zyxel Device.
MGMT Services Use this screen to enable specific traffic directions for network services.
Trust Domain Use this screen to view a list of public IP addresses which are allowed to
access the Zyxel Device through the services configured in the
Maintenance > Remote Management > MGMT Services screen.
SNMP Use this screen to configure SNMP (Simple Network Management
Protocol) settings.
Time Use this screen to change your Zyxel Device's time and date.
E-mail Use this screen to configure up to two mail servers and sender addresses
Notification on the Zyxel Device.
Log Setting Use this screen to change your Zyxel Device's log settings.
Firmware Use this screen to upload firmware to your Zyxel Device.
Upgrade
Backup/Restore Use this screen to backup and restore your Zyxel Device's configuration
(settings) or reset the factory default settings.
ROM-D Use this screen to save the current configuration as the defaults on the
Zyxel Device.
Reboot Use this screen to reboot the Zyxel Device without turning the power off.
Ping&Traceroute Use this screen to identify problems with the Zyxel Device. You can use
&Nslookup Ping, TraceRoute, or Nslookup to help you identify problems.
802.1ag Use this screen to configure CFM (Connectivity Fault Management) MD
(maintenance domain) and MA (maintenance association), perform
connectivity tests and view test reports.
802.3ah Use this screen to configure link OAM port parameters,
EX3510-B1 User's Guide
32