ZyXEL Communications EX3510-B1 User Manual page 53

• Configure a queue to assign the highest priority queue (1) to e-mail traffic going to the WAN
interface, so that e-mail traffic would not get delayed when there is network congestion.
• Note the IP address (192.168.1.23 for example) and/or MAC address (AA:FF:AA:FF:AA:FF for example)
of your computer and map it to queue 7.
Note: QoS is applied to traffic flowing out of the Zyxel Device.
Traffic that does not match this class is assigned a priority queue based on the internal QoS mapping
table on the Zyxel Device.
QoS Example
Your computer
IP=192.168.1.23
and/or
MAC=AA:FF:AA:FF:AA:FF
E-mail traffic: Highest priority
Click Network Setting > QoS > General and click the QoS button to enable. When the switch goes to the
1
right ( ), the function is enabled. Set your WAN Managed Upstream Bandwidth to 10,000 kbps (or
leave this blank to have the Zyxel Device automatically determine this figure). Click Apply.
Tutorial: Advanced > QoS
Click Network > Queue Setup > Add new Queue to create a new queue. In the screen that opens, click
2
the Active field to enable. When the switch goes to the right (
select the following values:
• Name: E-mail
• Interface: WAN
• Priority: 1 (High)
• Weight: 8
• Rate Limit: 5,000 (kbps)
Chapter 4 Tutorials
A colleague's computer
Other traffic: Automatic classifier
EX3510-B1 User's Guide
53
10,000 kbps
), the function is enabled. Enter or