Removing the PTT unit
When removing the PTT unit with the power
unit installed, make sure to suspend the
outboard motor.
TIP:
Fully tilt the swivel bracket up, and then sup-
port it using the tilt support knob "1".
Bleeding the PTT unit
Before removing the reservoir cap, make
sure that the trim and tilt ram is fully ex-
tended. Otherwise, fluid could be expelled
forcefully from the PTT unit due to internal
pressure.
1. Bleed:
• PTT unit
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Place the PTT unit in an upright position.
b. Turn the manual valve "1" counterclock-
wise to check that it is closed.
c. Remove the reservoir cap "1", and then
TIP:
If the fluid is at the proper level, a small amount
of fluid should flow out of the filler hole.
1
d. If the fluid is below the proper level, add
e. Install the reservoir cap, and then tighten it
1
9-27
Manual valve "1"
2.5 N·m (0.25 kgf·m, 1.8 lb·ft)
check the fluid level.
1
the recommended fluid.
to the specified torque.
Reservoir cap
7 N·m (0.7 kgf·m, 5.2 lb·ft)
PTT unit