Platform Overload System; How To Calibrate The Platform Overload System - Terex SX135XCH-101 Service And Repair Manual

Table of Contents

Advertisement

December 2018
11 Press the enter or previous button on the
LCD screen until EXIT is displayed.
12 Press the plus button or minus button to
select YES and then press the enter button.
13 Remove the fastener that was temporarily
installed. Close the control box door and install
the door retaining fasteners.
Note: When the control box door is closed, the
calibration toggle switch is automatically activated
to exit out of calibration mode.
Part No. 1263383GT
Platform Components
2-5

Platform Overload System

Proper calibration of the platform overload system
is essential to safe machine operation. Continued
use of an improperly calibrated platform overload
system could result in the system failing to sense
an overloaded platform. The stability of the
machine is compromised and it could tip over.
How to C alibr ate the Pl atform Overl oad System
How to Calibrate the Platform
Overload System
Note: Perform this procedure with the machine on
a firm, level surface and in the stowed position with
the axles extended.
1
Fully retract the boom and jib boom. Level the
platform.
2
Remove all equipment or tools from the
platform. Remove the welder if equipped.
3
Determine the maximum platform capacity.
Refer to the machine serial plate.
4
Push in the ground controls red Emergency
Stop button to the off position.
SX™-135 XC™
Service and Repair Manual
33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Genie sx-135xc

Table of Contents