Setting Up The Printer - Lexmark Optra T522 Setup Manual

Setting up the printer

Handhold
Tab
Round peg
6
In order to ensure adequate clearance when installing sys-
tem board options, see "Install memory and option cards"
starting on page 10 before you position the printer if:
CAUTION!
1
Square hole
2
Print cartridge
• You plan to install memory or option cards
and
• You will have less than 605.6 mm (24 in.) clear-
ance on the left side of the printer.
Make sure your fingers are not under the printer
when you set it down.
Ask someone to help you lift the printer by the hand-
holds and lower it onto the duplex unit, optional
drawer, table or printer cabinet.
The tab, round peg, and square holes on top of any
drawer or the duplex unit help you seat the printer
so the edges are aligned properly. Make sure the
printer is securely in place.
Remove the print cartridge packaging.
a
Push the release latch and open the printer
upper front door.
b
Grasp the print cartridge by the hand grip and
pull the print cartridge up and out.