Faxing
Faxing
Setting up the printer to fax
Notes:
•
The following connection methods are applicable only in some countries or regions.
•
During the initial printer setup, clear the fax function check box and any other function you plan to set up
later, and then select Continue.
•
If the fax function is enabled and not fully set up, then the indicator light may blink red.
Warning—Potential Damage: Do not touch cables or the printer in the area shown while actively sending or
receiving a fax.
Setting up the fax function
1
From the control panel, navigate to:
Settings > Device > Preferences > Run Initial Setup
For non-touch-screen printer models, press
2
Turn off the printer, wait for about 10 seconds, and then turn on the printer.
3
From the Before You Begin screen, select Change the Settings and Continue with the Wizard.
4
From the Fax/Email Server Setup screen, enter the needed information.
5
Finish the setup.
to navigate through the settings.
52