Turning On The Printer; Printing A Network Setup Page; Step 5: Verify Printer Setup - Lexmark Optra T522 Setup Manual

Step 5: Verify printer setup

Turning on the printer

Printing a network setup page

1
Plug one end of the printer power cord into the
socket at the back of the printer and the other end
into a properly grounded outlet.
2
Turn on the printer. If the printer is attached locally
(directly to a computer), leave the computer and any
other attached devices turned off. You will turn
these on in a later step.
The printer requires time to warm up after you turn it
on. During this period, the message Performing
Self Test appears on the operator panel display.
After the printer completes its internal tests, the
Ready message indicates the printer is ready to
receive jobs.
If you see other messages on the display, refer to
the Lexmark T522 Publications CD for instructions
on clearing the message. Click Printing, and then
click Understanding printer messages.
3
Go to "Printing a menu settings page" on page 22. If
you attached the printer to a network, see "Printing
a network setup page".
Note: You can change the language that appears on the
operator panel display. Refer to the Lexmark T522
Publications CD for instructions.
If the printer is attached to a network, print a network
setup page to verify the network connection. This page
also provides important information that will help you con-
figure for network printing.
21