Installing An Optional Firmware Card - Lexmark Optra T522 Setup Manual

Installing an optional
Warning!
Optional firmware cards are easily dam-
aged by static electricity. Touch something
metal on the printer before you touch a
card.
Pins
Card
Connectors
firmware card
Resting posts
Follow the instructions in this section to install an optional
firmware card. The system board has one location where
a firmware card can be installed.
1
Access the system board. (See page 10 for instruc-
tions.)
2
Unpack the firmware card.
Avoid touching the metal contacts on the connector.
Save the packaging.
3
Hold the firmware card by its edges, and align the
two pins on the card with the holes on the system
board.
Orient the card so that the pins are closest to the
bottom edge of the system board.
4
Push in until the firmware card is firmly in place.
Note: The entire length of the plastic connector must
touch the system board. Some force may be
required to fully install the firmware card.
5
Follow the steps in "Reattaching the shield and
closing the doors" on page 16.
13