Table of Contents
Advertisement
[Reset to the default (Except the network settings)]
Click the [Execute] button to reset the settings to the default. Note that the network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Load the default HTML files (setup menu).]
Click the [Execute] button to reset the HTML files to the default.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Reset to the default and load the default HTML files.]
Click the [Execute] button to reset the settings of the camera and the HTML files to the default. Note that the
network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
[Reboot]
Click the [Execute] button to reboot the camera. It is impossible to operate the camera for about 2 minutes
after rebooting the camera.
Note
•
To initialize the network settings (®page 130), turn off the power of the camera, then turn on the power
again while holding down the INITIAL SET button on the unit, and keep pressing the INITIAL SET
button for 10-15 seconds. Wait about 2 minutes after releasing the button. The camera will start up and
the settings including the network settings will be initialized. Do not turn off the power of the unit about
3 minutes after turning on the power.
•
The notification function allows users to provide the notification of the error to the specified destination
E-mail address and an original alarm destination when an error such as no SD memory card insertion
after the reboot or a locked SD memory card insertion occurs. (®page 135, page 117)
18.5 Settings data/backing up or restoring logs
[Data]
Click the [Data] tab of the "Maintenance" page. (®page 38, page 40)
18 Maintenance of the camera [Maintenance]
Operating Instructions
181
Advertisement
Table of Contents
