Table of Contents
Advertisement
15 Configure the settings relating to the authentication [User mng.]
Basic: Uses Basic authentication.
•
Default: Digest or Basic
Note
•
When the [Authentication] setting has been changed, close the web browser, and then access the
camera again.
•
For other devices such as network disk recorders, unless otherwise stated, Digest authentication is
not supported. (As of February, 2016)
[User name]
Enter a user name.
•
Available number of characters: 1 - 32 characters
•
Unavailable characters: " & : ; \
•
Default: None (blank)
Note
•
When the user name already in use is entered and the [Set] button is clicked, the respective user
information will be overwritten.
[Password] [Retype password]
Enter a password.
•
Available number of characters: 8 - 32 characters
•
Unavailable characters: " &
•
Default: None (blank)
Note
•
Distinguish between upper- and lower cases.
•
For the password, use two or more types of characters from alphabetic characters, numbers, and
symbols.
[Access level]
Select the access level of the user from the following.
•
1. Administrator: Allowed all available operations of the camera.
•
2. Camera control: Allowed to display images from the camera and to control the camera. The camera
setting configuration is unavailable.
•
3. Live only: Only displaying live images is available. The camera setting configuration and camera control
are unavailable.
•
Default: 3. Live only
[User check]
From the pull-down menu of "User check", the registered user can be selected and the selected user's
information can be checked.
The registered user will be displayed with the access level.
(Example: owner [1])
To delete the registered user, click the [Delete] button after selecting the user to be deleted.
15.2 Configure the settings relating to the host
authentication [Host auth.]
Click the [Host auth.] tab on the "User mng." page. (®page 38, page 40)
126
Operating Instructions
Advertisement
Table of Contents
