Table of Contents
Advertisement
•
Default: On
[Upside-down]
Select "On" or "Off" to determine whether or not to turn the image upside-down.
•
Default: Off
[Mirror]
Select "On" or "Off" to determine whether or not to turn the image over horizontally.
•
Default: Off
[Indicator]
Determine whether or not to use the following indicators. Select "On" to use the following indicators to check
the operational status by lighting them. Select "Off" to turn off the indicators at all times.
–
Link indicator (LINK)
–
Access indicator (ACT)
–
SD memory card error indicator (SD CARD)
•
Default: On
Note
•
Link indicator (LINK) (orange): This indicator will light when communication with the connected
device is available.
•
Access indicator (ACT) (green): This indicator will blink when accessing a network.
•
SD memory card error indicator (SD CARD) (red): Lights when an error occurred in the SD memory
card.
[Alarm status update mode]
Select an interval of the camera status notification from the following.
When the status of the camera changes, the alarm occurrence indication button or the SD saving status
indicator will be displayed to notify of the camera status.
•
Polling(30s): Updates the status each 30 seconds and provide notification of the camera status.
•
Real time: Provide notification of the camera status when the status has changed.
•
Default: Real time
Note
•
Depending on the network environment, notification may not be provided in real time.
•
When multiple cameras are using the same "Alarm status reception port", even if "Real time" is selected
for "Alarm status update mode", status notification is not provided in real time. In this case, change the
"Alarm status reception port" settings.
[Alarm status reception port]
When selecting "Real time" for "Alarm status update mode", designate a port number to which the status change
notification is to be sent.
•
Available port number: 1 - 65535
•
Default: 31004
The following port numbers are unavailable since they are already in use.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[Viewer software (nwcv4Ssetup.exe)] - [Automatic installation]
Determine whether or not to install the viewer software from this camera.
•
On: Installs the viewer software from the camera automatically.
•
Off: The viewer software cannot be installed from the camera.
•
Default: On
10 Configure the basic settings of the camera [Basic]
Operating Instructions
47
Advertisement
Table of Contents
