Settings Are Not Saved; Checking The Spool Settings For Banner Printing; Resolving Font Problems - Lexmark X5410 User Manual

D
O THE PRINT CARTRIDGES HAVE INK
1
Click Programs or All Programs
2
Click Solution Center.
If an exclamation point (!) appears on either of the print cartridges, the ink level is low. Install a new cartridge.
For more information, see the related topic below.
I
S THERE A PROBLEM WITH THE CONNECTIONS
For more information, see the related topic below.

Settings are not saved

These are possible solutions. Try one or more of the following:
C -
HANGE TIME OUT SETTINGS
If you press to select a setting, an * appears next to the selected setting. The printer reverts to the default setting
after two minutes of inactivity or if the printer is turned off.
S
AVE SETTINGS
If you press to select a setting, an * appears next to the selected setting.

Checking the Spool Settings for banner printing

Banner printing is not possible if certain Spool Settings are selected. Verify that you have the right settings selected.
1
Click Start Settings
2
Right-click the Lexmark X5400 Series icon.
3
Select Properties.
4
Click the Advanced tab.
5
At the bottom of the Advanced tab, click Print Processor.
6
Verify that the Default data type is LEMF. If it is not, select LEMF from the available choices, and then click OK.

Resolving font problems

H
AVE YOU APPLIED THE FONTS CORRECTLY IN THE PROGRAM
Most programs do not print a stretched or resized font.
I T
S THE FONT A RUE
The font you are trying to print may not be available in the program font selection box. Not all fonts are designed
to be printed; make sure the font is a TrueType font. See the program documentation for more information.
?
Lexmark X5400 Series.
Printers or Printers and Faxes.
T ? I
YPE FONT S IT AVAILABLE ON THE COMPUTER
Troubleshooting
?
?
102
?