Make Sure The Print Server Has Valid Network Settings; Cannot Print To The Network Printer; Check The Ethernet Cable; Make Sure The Power Is On - Lexmark X5410 User Manual

M
AKE SURE THE PRINT SERVER HAS VALID NETWORK SETTINGS
Print a network setup page and check the following. Refer to the print server User's Guide for instructions on how
to print a network setup page.
•
Verify that the IP address is correct for your network.
•
Verify that the gateway is correct.
•
Verify that the network mask is the same as the network mask used for other computers and printers on your
network.

Cannot print to the network printer

You must have an external print server (purchased separately) to connect the printer to your network.
C E
HECK THE THERNET CABLE
•
Check the Ethernet cable and the Ethernet connectors at both ends for any obvious damage.
•
Firmly plug one end of the Ethernet cable into the print server. Firmly plug the other end of the Ethernet cable
into the network hub or wall connection.
•
Try using a different cable. Damage to the cable may not be obvious.
M
AKE SURE THE POWER IS ON
•
Make sure the printer is connected to a power source and is turned on.
•
Make sure the print server is connected to a power source and is turned on.
M
AKE SURE THAT THE NETWORK IS OPERATING PROPERLY
•
Try to access other computers on the network.
•
Make sure all switches, hubs, and other connecting devices are turned on.
U
NINSTALL AND REINSTALL THE SOFTWARE
General networking
36