Canon OMNERA 500A Operator's Manual page 64

User Interface
Display User Interface
User Settings – Settings
USER SETTINGS
DISPLAY SETTINGS
Image
Preview on
Positioning image: auto popup
Localization
Unit
Screensaver
Timeout
Audio
Key Click
Sound
Sound on
LCD
Brightness
Logotype
On
Auto Position #
On
Fig. 3-20 Menu USER SETTINGS –
tab SETTINGS
– Image — Preview on
Position image: auto popup
– Localization — Unit
– Screensaver — Timeout
– Audio — Key Click
– Sound — Sound on
– Auto Position #
OMNERA 500A
SERVICE
THEMES
cm
10 mins
Beep when aligned,
tracking.
- +
Image
Preview on
Positioning image: auto popup
Localization
Unit
Screensaver
Timeout
Audio
Key Click
Sound
Sound on
LCD
Brightness
Logotype
On
Auto Position #
On
Fig. 3-21 Menu USER SETTINGS – tab SETTINGS
1000-095-071-EN Rev. 2.1
Page 56
In the SETTINGS tab it is possible to adjust
the following:
• Preview Image
• Localization, unit selection
• Screensaver, set time for activation
• Audio key click, On/Off
• Sound, On/Off
• LCD brightness, Plus/Minus
• Logotype in display, On/Off
• Autoposition, On/Off
cm
10 mins
Beep when aligned,
tracking.
- +
By selecting Preview on a small preview
image is shown next to the Active Protocol
name, see Fig. 3-22.
Unit changes between cm and inch, for
collimator light width and height values and
SID/H.
Select Screensaver — Timeout to
activate screensaver and set the time
(Off — 10 mins — I hour) for activation
using < or > .
By selecting Key Click a key click is heard
when touching the System display.
By selecting Sound — Sound on a beep is
heard when overhead tube crane is aligned
with the detector, at tracking.
By selecting Auto Position # the auto
position # is shown in the OTC display.
Operator´s Manual