Table of Contents
Advertisement
4.10.1.2 Change Between Portrait and Landscape
The method of rotating the detector in the detector holder, is as follows:
1. To rotate the detector by 90
side of the detector and turn it from the below, clockwise or anti-clockwise (2) while
pulling the latch upward or downward of the detector tray (1) in the direction of the arrow.
Fig. 4-39 Rotate detector
Note!
• To set the detector, pull the latch:
- upward at upper position of the tray.
- downward at the center of the tray.
• Depending on left— or right—operated wallstand, the location of the detector tray and
position of button and latches is different.
Centered or Top Rotation of the Detector
In the landscape position, there is a choice between having the detector rotated through the
detector center or through the detector top.
Fig. 4-40 Rotating detector
Operator´s Manual
Operating the System
o,
, in the step 2 of "Method to set the detector", hold the lower
1. Center position landscape
2. Top position landscape
2
3. Portrait
1
3
1000-095-071-EN Rev. 2.1
Page 121
Detector, Wallstand
OMNERA 500A
Advertisement
Table of Contents
