Operating the System
Detector, Wallstand
3. While pressing and holding the button of the detector tray, return it back to the inside of
the detector holder.
Fig. 4-44 Return detector
4. Push the detector until the hold-backs are set. Then the detector is in the correct position.
Chargeable detectors start charging when set in this position.
A
B
Fig. 4-45 Lock hold-back
CAUTION!
It is important that the hold-backs lock outside the detector end. Failure to position
the detector in the proper position leads to incorrect images.
Note!
If the detector or the detector holder is not properly inserted, a warning symbol is shown at
the display.
OMNERA 500A
A. Hold-back
B. Latch
1000-095-071-EN Rev. 2.1
Page 124
Operator´s Manual