Table of Contents
Advertisement
4.7.2.3 Flow of Operation
Fig. 4-23 Auto position mode display
• The overhead tube crane shows "H", distance to the floor.
Activate the mode by pressing the servo button.
• When auto-positioning to a wallstand, the wallstand detector unit moves into a basic
position.
• The overhead tube crane moves automatically to its programmed position.
• The servo mode button light indication is switched off.
All movements are available.
4.7.2.4 Exposure
Exposure is possible when the overhead tube crane is not moving.
Operator´s Manual
Operating the System
Free Examination Procedures
Select an Auto position mode examination.
The System display shows, see Fig. 4-23.
1000-095-071-EN Rev. 2.1
Page 107
OMNERA 500A
Advertisement
Table of Contents
