Table of Contents
Advertisement
The system is intended for use in the electromagnetic environment specified below. The
customer or the user of the system should assure that it is used in such an environment.
Guidance and manufacturer's declaration - electromagnetic emissions
Emissions test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions IEC
61000-3-2
Voltage fluctuations/
Flicker emissions IEC
61000-3-3
Guidance and manufacturer's declaration - electromagnetic emissions.
See 1000-095-072 Installation and Service Manual for tables including IEC 60601 test and
compliance levels, and recommended separation distances between portable and mobile
RF communications equipment and system.
Operator´s Manual
Electromagnetic environment - guidance
Compliance
The system uses RF energy only for its internal
Group 1
function. Therefore, its RF emissions are very low
and are not likely to cause any interference in
nearby electronic equipment.
Class B
The system is suitable for use in all establishments,
other than domestic and those directly connected to
Not applicable
the public low-voltage power supply network that
supplies buildings used for domestic purpose. For
information purpose the system complies with
Not applicable
IEC61000-3-11 and is suitable for connection to
public mains network if the impedance is 0.32 Ohm
or lower
1000-095-071-EN Rev. 2.1
Page 43
Electromagnetic Compatibility (EMC)
Safety
OMNERA 500A
Advertisement
Table of Contents
