Dell XC430 Owner's Manual page 9

Item Indicator, Button, or
Connector
2 NMI button
3 System identification
button
4 Video connector
5 LCD menu buttons
6 LCD panel
7 USB management port
or iDRAC managed USB
port
8 USB connector
9 Information tag
10 Hard drives
Icon Description
NOTE: On ACPI-compliant operating systems,
turning off the system by using the power
button causes the system to perform a
graceful shutdown before power to the
system is turned off.
Used to troubleshoot software and device driver
errors when running certain operating systems.
This button can be pressed using the end of a
paper clip.
Use this button only if directed to do so by
qualified support personnel or by the operating
system's documentation.
The identification buttons on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the LCD panel on the front and the
system status indicator on the back flashes until
one of the buttons is pressed again.
Press to toggle the system ID on and off.
If the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup)
press and hold the button for more than 15
seconds.
Allows you to connect a display to the system.
Allows you to navigate the control panel LCD
menu.
Displays system ID, status information, and system
error messages. See
The USB management port can function as a
regular USB port or provide access to the iDRAC
features. For more information, see the iDRAC
User's Guide available at Dell.com/idracmanuals.
Allows you to connect USB devices to the system.
The port is USB 2.0-compliant.
A slide-out label panel which contains system
information such as Service Tag, NIC, and MAC
address for your reference.
Up to four 3.5-inch hot-swappable hard drives or
SSDs.
LCD panel features.
9