Steps
1.
Install the system cover.
2.
If removed, install the optional front bezel.
3.
Reconnect the peripherals and connect the system to the electrical outlet.
4.
Turn on the system, including any attached peripherals.
Recommended tools
You will need the following items to perform the procedures in this section:
•
Key to the system keylock
•
#1 and #2 Phillips screwdriver
•
Wrist grounding strap connected to ground
Front bezel
Installing the optional front bezel
Prerequisites
1.
Follow the safety guidelines listed in the Safety instructions section.
Steps
1.
Locate and remove the bezel key.
NOTE: The bezel key is attached to the back of the bezel.
2.
Hook the right end of the bezel onto the chassis.
3.
Fit the free end of the bezel onto the system.
4.
Lock the bezel by using the key.
Removing the optional front bezel
1.
Unlock the keylock at the left end of the bezel.
2.
Lift the release latch next to the keylock.
3.
Rotate the left end of the bezel away from the front panel.
4.
Unhook the right end of the bezel and pull the bezel away from the system.
System cover
Removing the system cover
Prerequisites
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
If installed, remove the optional bezel. For more information, see the Removing the optional front
bezel section.
3.
If installed, remove the front bezel.
42