Dell XC430 Owner's Manual page 90

CAUTION: Take care not to damage the system identification button while placing the system
board into the chassis.
1. Ensure that you read the
2. Unpack the new system board assembly.
Steps
1. Hold the system board by its edges and the system board t-handle, and angle it toward the back of
the chassis.
2. Lower the system board into the chassis till the connectors at the back of the system board align
with the slots on the rear wall of the chassis, and the screw holes on the system board align with the
standoffs on the chassis.
3. Tighten the nine screws that secure the system board to the chassis.
Next steps
1. Install the Trusted Platform Module (TPM). See,
2. Replace the following:
a. internal dual SD module
b. heat sink or heat-sink blank and processor or processor blank
c. expansion-card riser
d. expansion cards
e. integrated storage controller card
f. cooling fan cables
g. memory modules
h. cooling shroud
3. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed through the cable routing latch.
4. Follow the procedure listed in
5. Import your new or existing iDRAC Enterprise license. For more information, see the Integrated Dell
Remote Access Controller User's Guide available at Dell.com/support/home.
6. Ensure that you:
a. Use the Easy Restore feature to restore the service tag. See
Restore.
b. If the Service Tag is not backed up in the backup flash device, enter the system service tag
manually. See
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). See
Re-enabling the TPM for TXT
90
Safety instructions.
After working inside your
Entering the system Service Tag using System
users.
Installing the Trusted Platform Module
system.
Restoring the Service Tag using Easy
Setup.
Re-enabling the TPM for BitLocker users
.
or