Table of Contents
Advertisement
4
Collimate
P,and
"Measure" key.
⑤Collimate
target
with horizontal clamp
and tangent part.
5
Click
"Continue"
key.Then
distance,horizontal
distance
elevation difference
from instrument to
A0 and coordinate of
A0 will be shown.
※1)，※2)
※1) Click "Setup" key to set instrument height and prism height.
※2)Click "Exit" to finish Angle Offset Measurement
●Set instrument height/prism height before Offset Measurement.
●Refer to "4.5.1" to set coordinate of occupied point.
2) Distance Offset Measurement
The measurement of a target point apart from a prism is possible by
inputting offset horizontal distance of front and back/left and right.
prism
Collimate
click
prism P
A0
Collimate
A0
slope
and
【 Continue
】
65
Advertisement
Table of Contents
