Omron V430-F Series User Manual For Communication Settings page 122

・AutoImage Photometry Enabled
This bit is set to 1 when Auto Photometry is used.
This bit is set to 0 when AutoImage Photometry is complete.
・AutoImage Photometry Complete
This bit is set to 1 when AutoImage Photometry processing is complete. If an error occurs, it is out-
put by Fault Code area.
・Output 1 Status
Indicates the current state of the Parallel OUTPUT 1 signal.
・Output 2 Status
Indicates the current state of the Parallel OUTPUT 2 signal.
・Output 3 Status
Indicates the current state of the Parallel OUTPUT 3 signal.
・Buffer Overflow
This bit is set to 1 when the read string length exceeds the size of the Decode Data area.
• Fault Code
Outputs Error information when a code reader error occurs.
It can be set from the Command field of the Output Assembly.
0
1
2
3
4 - 31
・Command Error Detected
This bit is set to 1 when a Serial command fails to be executed.
・Communication Error
This bit is set to 1 when a data error condition is detected in Serial (RS-232C) communication.
・Host Port Buffer Overflow
This bit is set to 1 when a character string larger than the size set for the Decode Data area is re-
ceived.
• Counters
Various counters of Read results after starting the device are output.
These counters can be set from the Command Field/Area of the Output Assembly.
No Read Read Cycle Counter
Mismatch per Read Cycle Counter
No Read Counter
Trigger Counter
Matchcode Counter
Mismatch Counter
・No Read Read Cycle Counter
Outputs the total number of Read Cycle No Reads.
・Mismatch per Read Cycle Counter
Outputs the total number of Read Cycle Mismatches.
・No Read Counter
V430-F Series Autofocus Multicode Reader User Manual for Communication Settings
Bit
Command Error Detected
Communication Error
Reserved
Host Port Buffer Overflow
Reserved
Counters
Appendices
State
Size (Bytes)
4
4
4
4
4
4
A
A - 11