Table of Contents
Advertisement
CHK
ADJ
Control system
3
2
LT
a
242
4
5
b
7
8
6
3-6
5. If the throttle cable installation length a is
out of specification, loosen the locknut 2,
and then turn the adjusting nut 3 to adjust
the length.
6. Apply locking agent to the threads of the
adjusting nut 3, and then tighten the lock-
nut 2 to the specified torque.
Locknut:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
LOCTITE 242
7. Remove the upper handlebar cover 4.
8. Move the handlebar bracket 5 to the low-
est position.
NOTICE
Make sure to adjust the free play with the
handlebar bracket in the lowest position.
Otherwise, the specified free play with the
handlebar bracket in the highest position
cannot be obtained.
9. Slide the rubber cover 6 away from the
throttle lever.
10. Loosen the locknut 7.
11. Turn the adjuster 8 in or out until the
specified free play is obtained.
Turn in
Free play is increased.
Turn out
Free play is decreased.
Throttle lever free play b with
handlebar bracket in lowest position:
2.0 mm (0.08 in)
12. Tighten the locknut 7.
E
1
2
3
4
5
6
7
8
9
Advertisement
Chapters
Table of Contents
