Table of Contents
Advertisement
POWR
2
1
5
7
4
7
6
3
Generator cover and flywheel magneto
4
3
Flywheel magneto removal
WARNING
When using a heat gun, protect your hands
by wearing heat-resistant gloves. Compo-
nents become hot enough to cause burns.
1. Remove:
• Generator cover assembly
• Transfer shaft assembly 1
Removal steps:
1. Remove the generator cover assembly.
2. Heat the transfer shaft assembly 1 for 20-
30 minutes with a heat gun 2.
NOTICE
• Do not use a gas torch.
• Be careful not to damage the wiring har-
ness when using the heat gun.
TIP
Heat the transfer shaft assembly 1 with a heat
gun 2 at approximately 200 °C (392 °F).
3. Hold the flywheel magneto 3 with the spe-
cial service tools 4 and 5, and then
loosen the special nut 6 with a hexagon
bit socket 7.
TIP
• Loosen the special nut 6 until it can no
longer be turned.
• Use a 12 mm hexagon bit socket 7 with a
length of 150 mm or more.
5-83
E
1
2
3
4
6
7
8
9
Advertisement
Chapters
Table of Contents
