Yamaha WaveRunner FZR-GX1800 Service Manual page 230

JET
PUMP
3
M
2
4 b 6
A A
7
a
8
Jet pump unit
1
1194E
2
5
A A
LT
242
Installation steps:
1. Clean the contacting surfaces of the jet
pump unit 1 and transom plate 2.
2. Apply sealant to the contacting surfaces of
the transom plate 2.
3. Install the jet pump unit 1.
TIP
Rotate the drive shaft 3 to align the splines on
the drive shaft with the splines on the inside of
the intermediate drive shaft.
Jet pump unit assembly bolt:
M10
40 N·m (4.0 kgf·m, 29.5 ft·lb)
LOCTITE 572
M6
8 N·m (0.8 kgf·m, 5.9 ft·lb)
LOCTITE 572
4. Install the rubber plates 4 and 5, spout
hose 6, QSTS rod joint 7, shift cable joint
8, and steering cable joint 9.
TIP
• When installing the rubber plate 4, pass the
shift cable through the hole a in the plate.
• When installing the rubber plate 5, pass the
9 spout hose 6 through the hole b in the
plate.
• Make sure that the steering, shifting, and
QSTS operate correctly.
Rubber plate bolt:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
LOCTITE 572
Spout hose clamp:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
Steering cable joint:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
LOCTITE 242
6-5
×
45 mm:
×
30 mm:
E
1
2
3
4
5
7
8
9