Yamaha WaveRunner FZR-GX1800 Service Manual page 199

POWR
Generator cover and flywheel magneto
3
a
4
6
2
4
8
4
8
7
2
10. Tighten the transfer shaft assembly to the
60˚
OK
If the mark a on the transfer shaft assem-
bly 3 moves past the 120° mark on the
120˚ special service tool 4 before the specified
torque is reached, repeat the procedure
from step 1.
11. Hold the flywheel magneto assembly 2
TIP
Use a 12 mm hexagon bit socket 8 with a
5
length of 150 mm or more.
12. Install the generator cover assembly.
To allow the LT648 to set, wait approxi-
mately 1 hour after completing this proce-
dure.
5-92
specified torque with the special service
tool 6.
NOTICE
Transfer shaft assembly 3:
250 N·m (25.0 kgf·m, 184.4 ft·lb)
with the special service tools 4 and 5,
and then tighten the special nut 7 to the
specified torque with a hexagon bit socket
8.
Shaft holder 4:
90890-06721
Driver handle 5:
90890-06722
Special nut 7:
250 N·m (25.0 kgf·m, 184.4 ft·lb)
NOTICE
E
1
2
3
4
5
6
7
8
9