Table of Contents
Advertisement
POWR
Generator cover and flywheel magneto
1
b
c
A
2
3
1
a
A A
LT
648
LT
648
b
3. Install:
• Woodruff key 1
• Flywheel magneto assembly 2
• Transfer shaft assembly 3
• Generator cover assembly
Installation steps:
1. Remove any grease from the tapered por-
tion a and threaded portion b of the
crankshaft and the inner surface c of the
flywheel magneto 2.
NOTICE
Make sure to remove any grease from the
tapered portion a of the crankshaft and the
inner surface c of the flywheel magneto
assembly 2, otherwise the flywheel mag-
neto assembly cannot be installed proper-
ly.
2. Install the Woodruff key 1 and flywheel
magneto assembly 2.
NOTICE
• Do not reuse the Woodruff key 1 and
transfer shaft assembly 3, always re-
place them with new ones.
• Make sure to install the Woodruff key 1
so that its flat end is pointing toward the
end of the crankshaft as shown.
3. Apply a line of LT648 onto the end of the
crankshaft as shown.
4. Apply recommended lubricant to the mat-
ing surfaces between the flywheel mag-
neto 2 and the transfer shaft 3.
Recommended lubricant:
Yamaha grease A
5. Install the transfer shaft assembly 3.
5-90
E
1
2
3
4
5
6
7
8
9
Advertisement
Chapters
Table of Contents
