Table of Contents
Advertisement
Items Related to Prerolling (400s)
The values enclosed in a box are factory settings.
Item number
Item
401
FUNCTION MODE
AFTER CUE-UP
AUTOMATIC
403
PREROLL
REFERENCE
ENTRY
CUEUP BY TC
404
CUEUP BY CTL
405
a) When this unit is controlled by an editor (BVE-2000/BVE-9100, etc), and the seting is "1", cue up operations are done at
high speed.
Settable range
Function
Selects the operation mode that the VTR changes to after
[0]
[stop]
completing a cue up operation.
1
still
0 : Enters stop mode.
1 : Enters still-picture mode (search mode).
Note
When setting the standard constant on the editor and
control the unit, set to "0."
[0]
[disable]
Specifies whether IN point is automatically set when the
1
enable
PREROLL button is pressed, in the case no IN point has
been set at the start of a preroll operation.
0 : IN point is not set automatically.
1 : IN point is set automatically.
0
The setting of this item is valid only when the [F1] (TIMER
capstan only
[1]
[reel/capstan]
SEL) button in the TC menu is set to TC or UBIT.
0 : The tape runs with the pinch ON during cue up. (The
1 : The tape runs with the pinch OFF state during cue up.
Select "0" when the tape contains a discontinuity in its
time code signal and the part that is prerolled contains the
discontinuity. (Prerolling is performed by interpolating the
time code preceding the discontinuity using the CTL
signals.)
The setting of this item is valid only when the [F1] (TIMER
[0]
[capstan only]
SEL) button in the TC menu is set to CTL.
1
reel/capstan
0 : The tape runs with the pinch ON state during cue up.
1 : The tape runs with the pinch OFF state during cue up.
Select "0" when editing precision has priority.
maximum tape speed is ten times normal tape speed.)
When the tape nears the cue up point and tape speed
drops to slow, the pinch turns ON.
(The maximum tape speed is ten times normal tape
speed.)
When the tape nears the cue up point and tape speed
drops to slow, the pinch turns ON
a)
.
A-19
Appendix
Advertisement
Table of Contents
