Sony DVW-A510 Operation Manual page 147

Item number Item
704 DECODE Y/C
SEP MODE
(DVW-A500/1
and 500/1 with
optional
accessory
BKDW-505)
Sub item
12
Line 12
I I
20
Line 20
704 DECODE Y/C
SEP MODE
(DVW-A500P/1
and 500P/1 with
optional
accessory
BKDW-506)
Sub item
9 Line 9.332
I
I
22 Line 22.335
705
EDGE
SUBCARRIER
REDUCER MODE
706 VERTICAL
BLANKING V
SHIFT
707
FORCED
VERTICAL
INTERPORATION
OFF
Settable range Function
Specifies the Y/C separation mode during vertical blanking.
0 BPF
Can be specified independently for each line from line 12 to
[1] [B W]
&
20. Valid only when the BKDW-505 Analog Composite
Decoder Board is installed.
0: Signals are processed as Y/C.
1: Signals are processed as luminance signals.
Specifies the Y/C separation mode during vertical blanking.
0 BPF
[1] [B W] Can be specified independently for each line from line 12 to
&
20. Valid only when the BKDW-506 Analog Composite
Decoder Board is installed.
0: Signals are processed as Y/C.
1: Signals are processed as luminance signals.
[0] During recording and playback of composite signals, the
[auto]
1 ESR (Edge Subcarrier Reducer) automatically goes on or
forced ESR on
off, depending on the VTR operation. Through this item,
the ESR can also be set to stay on all the time when the
color edge has more noise, as when recording a non-
standard signal.
0: The ESR turns on and off automatically.
1: The ESR stays on all the time.
[0] [on] During the Y-add operation mode, the playback signal is
off shifted by 1H to suppress vertical movement of the
1
playback picture when the playback is an odd field and the
reference signal an even field.
This item is specified whether the 1H shift is applied or not
during the V-blanking period. If it is, the video playback
signal appears sporadically on line 21 during DT playback.
0: The shift is applied during V-blanking.
1: The shift is not applied during V-blanking.
Note
In a Y-add operation, vertical interpolation is conducted
during DT playback in order to decrease vertical movement
of the playback picture.
[auto]
[0] Specifies whether Y-add operation mode is automatically
forced YADD off turned on during DT playback or not.
1
0: Y-add operation mode is automatically turned on.
1: Y-add operation mode is off all the time.
A-25
Appendix