Installing the software in the HP 16505A
Prototype Analyzer
To install the HP E3491A software (Run Control Tool) in the
HP 16505A Prototype Analyzer:
•
Power up the prototype analyzer.
•
Insert the HP E3491A floppy disk in the floppy disk drive.
•
In the Session Manager menu, select Update. The prototype
analyzer will read the directory of the floppy disk.
•
When the menu changes to show the file group "E3491A", select
Update/Install. The menu will query "Install the file group
E3491A?" Select OK. When the installation is complete, the menu
will display ""Filegroup E3491A successfully installed." Select OK.
•
Close the HP 16505A Update/Install window.
•
To verify installation, start a session in the HP 16505A. Look for
the µp Control Tool in the Toolbar. If the µp Control Tool is in the
Toolbar, the installation is complete.
5