Connecting to the Target System
Connectors provided
Connecting to a Target System
The E3491A Pentium Probe can be connected to a target system by
the methods listed below.
•
Directly through the Intel defined 20- or 30-pin debug connector.
•
Through the HP E2457A Pentium Preprocessor Interface.
•
Through a custom designed interface.
This chapter describes the procedures to connect to the Intel defined
debug connectors and the E2457A Pentium preprocessor. To design a
custom interface refer to chapter 3 "Designing a target system for use
with the Intel-defined debug interface."
Connectors provided
The following components are provided with the E3491A Pentium probe for
the purpose of testing the probe and connecting to a target system.
•
A 20-conductor cable assembly (HP part number E3491-61601)
•
A 30-conductor cable assembly (HP part number E3491-61602)
•
An adapter board (HP part number E2491-66503)
•
A 2-conductor cable assembly with SMT Grabbers (HP part number
64762-61602)
•
A self-test connector (HP part number E3490-61604)
22