HP E3491A Installation And Service Manual page 2

HP E3491A Pentium Probe—At a Glance
The HP E3491A Pentium Probe provides
a low-cost way to debug embedded
software for Intel Pentium™
microprocessors. It can also be used
with the HP E2457A Preprocessor
Interface for microprocessor code
disassembly.
The target connection
The HP E3491A Pentium Probe connects
to your target microprocessor via a
special connector on the target system,
or through the HP E2457A Preprocessor
Interface.
The HP 16505A connection
The HP E3491A Pentium Probe connects
to the HP 16505A Prototype Analyzer via
an Ethernet LAN for remote operation,
or directly for point-to-point operation.
The logic analyzer connects to the
HP 16505A through a SCSI connector.
The configuration switches
Use the switches to configure
communication to the HP 16505A. There
is a guide to these switches on the
bottom of the HP E3491A Pentium Probe.
ii
The status LEDs
LEDs show the status of the power
supply, the target system, and the
connection to the HP 16505A.
Additonal equipment required
The HP E3491A Pentium Probe requires
the HP 16505A Prototype Analzer.
Compatibility with other products
The HP E3491A Pentium Probe and
HP 16505A Prototype Analyzer can also
be used with the HP E2457A
Preprocessor Interface.