Setting Up a Serial Connection
To configure LAN parameters using the built-in terminal interface
Once you have set a valid IP address, you can use prototype analyzer to verify
LAN communication.
Example
For example, to assign an IP address of 192.6.94.2 to the HP E3491A Pentium
Probe, enter the following command:
R>lan -i 192.6.94.2
The IP address and any other LAN parameters you change are stored in
nonvolatile memory and will take effect the next time the HP E3491A
Pentium Probe is powered off and back on again.
See Also
"Solving Problems," page 39, if you have problems verifying LAN
communication.
20