Table of Contents
Advertisement
5. Press
6. Press
7. Press
Calibration (as needed only)
If the scanned image has vertical lines or discolorations, the scanner may need calibrating in
order for the Contact Image Sensor (CIS) to resume its color & sharpness precision.
Do not calibrate the scanner unless it is necessary to correct scanned image problems.
For calibration instructions, see the "Calibrate the Scanner" section on page 35.
Factory Default
At any time you can reset all menu settings back to the factory defaults. To reset defaults:
1. With the
2. Press
3. Press
4. Press
5. To confirm, press
6. After a successful reset, the scanner automatically shuts off. Press
scanner back on.
About
The About option lists the current Firmware and Calibration versions.
You may need this information if you contact our Customer Support.
1. With the
2. Press
3. Press
Use of P ro te ct i ve Sl e eve s (o pt io n al)
5"x7" protective sleeves (not included with the scanner) can be purchased on our website:
www.pandigital.net.
We recommend using a 5"x7" protective sleeve for your older, fragile photos and when scanning
originals smaller than 2"x2" using the feeder dock.
The protective sleeves also help to eliminate the possibility of de-focusing due to the uneven
surface of curled photos.
Curled photo
22
to set the value.
to accept values and to complete.
to exit.
screen displayed, press
Settings
to select
Factory Default
to scroll to
Yes
to select
.
.
screen displayed, press
Settings
to select
.
About
to scroll to
, and then press
to enter Menu mode.
.
, and then press
to enter Menu mode.
to select it.
Fuzzy areas that result from the uneven
surface of the curled photo
to select it.
to turn the
Advertisement
Table of Contents
