Subaru IMPREZA 2004 Service Manual page 55

2) Tighten the base COMPL fixing bolt.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
3) Set the height gauge to adapter plate. Lower the
indicator of height gauge to mating surface of
adapter plate and case, then set to zero point.
ST 18853AA000 HEIGHT GAUGE
ST
NOTE:
• Remove the remaining gasket on edge surface
with scraper, since the adapter plate is base point
of measurement.
• Do not place the height gauge on shaded area in
the figure during measurement.
Shifter Fork and Rod
4) Press the reverse sleeve to reverse side idler
gear No. 2, then measure "T".
MT-00546
MT-00582
NOTE:
• Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
reverse sleeve side.
• Measure five points of the sleeve turning every
approx. 72°. Round off each two upper and lower
measurement value. Use the remaining center val-
ue as measurement value.
MT-00583
6MT-123
MANUAL TRANSMISSION AND DIFFERENTIAL
T
(A) Reverse idler gear No. 2
(A)
(A) Reverse idler gear No. 2
(A)
MT-00715
MT-00716
(2)
(1)
MT-00585