Subaru IMPREZA 2004 Service Manual page 39

3) Remove the claw of ST1, and then install the
claw of ST2.
ST1 398527700 PULLER ASSY
ST2 18760AA000 CLAW
ST1
(A) Claw
4) Remove the bearing outer race from side retain-
er.
ST1 398527700 PULLER ASSY
ST2 398527705 CLAW
(A) Side retainer
Front Differential Assembly
D: ASSEMBLY
1. DIFFERENTIAL CASE
1) Using the ST, install a new speedometer drive
gear and right and left side bearing inner race to dif-
ferential case.
ST1 398437700
ST2 398497701
CAUTION:
(A)
Do not apply pressure in excess of 20 kN (2.0
ton, 2.2 US ton, 2.0 Imp ton).
NOTE:
Always replace the inner race and outer race as a
set.
2) Install the hypoid driven gear to differential case.
ST2
Tightening torque:
MT-00668
2. SIDE RETAINER
NOTE:
Install the oil seal and O-ring of side retainer after
the adjustment of backlash and tooth contact.
1) Install the bearing outer race to side retainer.
ST1
2) Fit a new oil seal using ST.
ST 18675AA000 DIFFERENTIAL SIDE OIL
ST2
NOTE:
Apply oil to the oil seal lips.
(A)
MT-00669
6MT-107
MANUAL TRANSMISSION AND DIFFERENTIAL
INSTALLER
SEAT
69 N·m (7.0 kgf-m, 50.9 ft-lb)
SEAL INSTALLER
ST
MT-00660
AT-00226